News
The use of precision CNC lathes
Release time:
Oct 17,2023
The normal operation of a CNC lathe must meet the following conditions: the power supply voltage at the location of the machine tool fluctuates slightly, the ambient temperature is below 30 degrees Celsius, and the relative temperature is less than 80%.
Requirements for machine tool positioning environment
The direction of the machine tool should be away from vibration sources, avoiding direct sunlight and thermal radiation, and avoiding the influence of moisture and airflow. If there is a vibration source near the machine tool, anti vibration grooves should be set up around the machine tool. Otherwise, it will directly affect the machining accuracy and stability of the machine tool, leading to poor contact of electronic components, causing problems, and affecting the reliability of the machine tool.
II Power Requirements
Usually, the CNC lathe device in the machining workshop not only has significant environmental temperature changes and harsh operating conditions, but also has a variety of mechanical and electrical equipment, causing significant fluctuations in the power grid. Therefore, the positioning of CNC lathes requires strict control of the power supply voltage. The voltage fluctuation of the power supply must be within the allowable range and relatively stable. Otherwise, it will affect the normal operation of the CNC system.
III temperature conditions
The ambient temperature of a CNC lathe is below 30 degrees Celsius, and the relative temperature is less than 80%. Generally speaking, the CNC control box is equipped with exhaust fans or cooling fans inside to maintain the stable operating temperature or minimum temperature difference of electronic components, especially the central processing unit. Excessive temperature and humidity can lead to a decrease in the lifespan of control system components and an increase in defects. The increase in temperature and humidity, as well as the increase in dust, can cause adhesion and short circuits on the integrated circuit board.
IV Use the machine tool according to the instructions
Users are not allowed to arbitrarily change the parameters set by the manufacturer in the control system when using the machine tool. The setting of these parameters is directly related to the dynamic characteristics of various components of the machine tool. As long as the gap compensation parameter value can be adjusted according to the actual situation.